Impulse group switch for central control, 1+1 NO contacts not potential free 10A/250V AC, for one 230V AC motor. Standby loss 0.4 watt only. For installation. 45mm long, 45mm wide, 32mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. This impulse group switch serves to implement commands generated by the sensor relays or by switches and pushbuttons and controls a 230V motor for a shading element or a roller shutter. Control, supply and switching voltage 230V. The same control voltage must be supplied to A1, A7 and A8 as to L. By using bistable relays coil power loss and heating is avoided even in the on mode. The switched consumer may not be connected to the mains before the short automatic synchronisation after installation has terminated. A universal pushbutton connected to control input A1 controls the pulse signals for up, stop, down, stop. A direction pushbutton for down can be connected via the diode RTD (any polarity). Another direction pushbutton for up is connected directly to A1. On the first control pulse down, EGS61Z switches over the control input A1 to direction pushbutton. To switch the control input back to universal pushbutton, briefly switch off the power supply and switch back on. Additional control inputs A7 and A8 can be used for central control UP or DOWN with priority. With priority because these control inputs cannot be overridden by other control inputs as long as the central control contact is closed. Up or DOWN is activated by a control signal. A further control signal (< 700ms) at this control imput interrupts this process immediately, a further control signal (> 700ms) continues the process. The time delay (delay time RV) is set by means of the rotary switch RV. If, the group impulse switch is in the UP or DOWN position the selected delay time runs (elapses)
* Recommended retail price plus VAT.